Inspection Procedure 10: The Select Shock Is Large When the Transmission Range Is Shifted From "N" to "D", and "N" to "R."

INSPECTION PROCEDURE 10: The select shock is large when the transmission range is shifted from "N" to "D", and "N" to "R."

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CONDITION:)
^ Malfunction of the engine: Idle speed
^ Poor adjustment of transmission range switch
^ Malfunction of the TCM
^ A/T failure: Hydraulic system (valve body assembly), driving force transmission system (clutch/brake)

DIAGNOSIS

STEP 1. Check the engine performance.
Especially check that the idle speed does not exceed the specified value.

Q:Is the check result normal?
YES: Go to Step 2.
NO: Repair the failure, and perform adjustment.

STEP 2. Check and adjust the transmission range switch.
If the transmission range switch has a failure, replace it, and then check the trouble symptom again.

Q:Is the check result normal?
YES: The procedure is complete.
NO: Go to Step 3.

STEP 3. Replace the TCM.

Q:Is the failure resolved?
YES: The procedure is complete.
NO: Go to Step 4.

STEP 4. Compare with another same model vehicle.

Q:Is there a difference from the same model vehicle?
YES: Go to Step 5.
NO: The procedure is complete.

STEP 5. Remove the transaxle assembly from the vehicle.
Disassemble and check the transaxle assembly to check if there is a foreign material inside.

Q:Is the check result satisfactory?
YES: Replace the transaxle assembly.
NO: Replace the failure part.