Shifter CVT: Service and Repair
TRANSAXLE CONTROLREMOVAL AND INSTALLATION
CAUTION: Before removing the clock spring connector, refer to SRS Air Bag Service Precautions and Air Bag Module and Clock Spring.
Pre-removal & Post-installation Operation:
Removal Steps 1-7:
REMOVAL SERVICE POINTS
[[A]] SELECTOR LEVER KNOB REMOVAL
Pull out the selector lever knob to the direction of arrow shown in the figure.
INSTALLATION SERVICE POINTS
]]A[[ TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE) INSTALLATION
1. Move the selector lever and manual control lever to the N position.
2. Use the adjusting nut to tighten the transaxle control cable to the specified torque.
Tightening torque: 9.5 ± 3.5 Nm (84 ± 31 in-lb)
]]B[[ KEY INTERLOCK CABLE INSTALLATION
CAUTION: Leave the ignition switch in the LOCK (OFF) position until the key interlock cable installation is completed.
1. Move the selector lever to the P position and turn the ignition switch to the LOCK (OFF) position.
2. Install the tip of the key interlock cable to the lock cam of the selector lever assembly, taking care not to twist the inner cable.
3. Install the adjuster case with its lock guide pulled up (unlocked).
4. Securely push down the lock guide to lock it.
NOTE: The lock position of the key interlock cable is automatically adjusted by a spring.