Continuously Variable Transaxle

TRANSFER ASSEMBLY [AWD]

REMOVAL AND INSTALLATION

Pre-removal & Post-installation Operation:

Removal Steps 1-5:

REMOVAL SERVICE POINTS

[[A]] TRANSFER ASSEMBLY REMOVAL
Move the engine and transaxle assembly toward the front of the vehicle to make a gap between the engine/transaxle assembly and the crossmember. Pull out the transfer assembly through this gap.

INSTALLATION SERVICE POINTS

]]A[[ EXHAUST MANIFOLD BRACKET B INSTALLATION





1. Make sure that the exhaust manifold bracket is closely contacted with the exhaust manifold and transfer assembly, and then temporarily tighten the bolts.
2. Tighten bolt on the exhaust manifold side in the figure to the specified torque.

Tightening torque: 20 ± 5 Nm (15 ± 3 ft-lb)

3. Tighten bolt B on the transfer assembly side in the figure to the specified torque.

Tightening torque: 20 ± 5 Nm (15 ± 3 ft-lb)