Inspection Procedure 2: The Vehicle Does Not Run at the "D" or the "R" Range

INSPECTION PROCEDURE 2: The vehicle does not run at the "D" or the "R" range.

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CONDITION:) (clutch/brake)
^ Poor adjustment of transaxle control cable
^ A/T failure: Hydraulic system (valve body assembly), driving force transmission system

DIAGNOSIS

STEP 1. Check the transaxle control cable.
Check the installation status of transaxle control cable and transmission range switch.

Q:Is the check result normal?
YES: Go to Step 2.
NO: Adjust the installation status of transaxle control cable and transmission range switch.

STEP 2. Check the transmission fluid.
Check the transmission fluid for seizure, fouling, and level.

Q:Is the check result normal?
YES: The procedure is complete.
NO: Go to Step 3.

STEP 3. Remove the transaxle assembly from the vehicle.
Disassemble and check the transaxle assembly to check if there is a foreign material inside.

Q:Is the check result satisfactory?
YES: Replace the transaxle assembly.
NO: Replace the failure part.