Module/Frame Assembly

MODULE/FRAME ASSEMBLY

REMOVAL

1. Move glass panel to fully closed position.
2. Disconnect and isolate negative battery cable.
3. Remove control switch.
4. Remove headliner.






5. Disconnect wire harness push in fasteners electrical connector from vehicle harness.
6. Disconnect drain tubes from sunroof housing.
7. Cut foam support pad at rear of module if necessary.
8. Remove two module side bracket bolts (2) and loosen the six remaining fasteners.
9. With the aid of a helper, remove the six (2) fasteners attaching sunroof module assembly (1) to roof panel.
10. Remove the glass panel.
11. Remove the sunshade.
12. Remove the drive motor.
13. Remove the wire harness.
14. Remove the sight shields.
15. Remove the trough guides.

INSTALLATION

1. Install the trough guides.
2. Install the sight shields.
3. Install the drive motor.
4. Install the sunshade.
5. Install the glass panel.






6. Remove the backing tape from the foam support pad, if necessary.
7. Raise rear end of sunroof module assembly and guide into position and start fasteners.
8. Tighten the fasteners to 9 N.m (80 in.lbs.).
9. Connect the drain tubes.
10. Install the wire harness.
11. Connect battery negative cable.
12. Test sunroof operation, adjust glass as necessary.
13. Partially install the headliner and connect the sunroof wiring electrical connectors.
14. Temporarily install sunroof switch and perform the sunroof motor teach procedure.
15. Complete headliner installation.
16. Verify correct sunroof operation.