How to Initialize CVT Learned Value

HOW TO INITIALIZE CVT LEARNED VALUE

AIM
After the CVT assembly, engine assembly, and valve body assembly are replaced, their learned value must be initialized. The initialization procedure is as below.

INITIALIZATION PROCEDURE
1. Move the selector lever to the "P" range and turn the ignition switch to the "LOCK" (OFF) position. Then, connect M.U.T-III to the diagnosis connector.
2. Turn the ignition switch to the "ON" position, and then move the selector lever to the "R" range.
3. Depress the accelerator pedal while depressing the brake pedal. (Engine stops.) Perform the operation to erase the DTC under this condition (even if no codes are set).

NOTE: Performing initialization of the learned value will also erase the diagnosis code.