Removal and Replacement
KNOCK SENSORREMOVAL AND INSTALLATION [2.0L ENGINE NON-TURBO, 2.4L ENGINE]
CAUTION:
- When the knock sensor replacement is performed, use scan tool MB991958 to initialize the learning value (Refer to Precautions Before Service - Initialization Procedure for Learning Value in MFI Engine)
- Do not drop or hit the knock sensor against other components. Internal damage may result, and the knock sensor will need to be replaced.
Pre-removal & Post-installation Operation:
Removal Steps 1-2:
REMOVAL SERVICE POINT
[[A]] THROTTLE BODY MOUNTING BOLTS REMOVAL
Remove the throttle body mounting bolts and put the throttle body aside so as not to interfere the knock sensor connector disconnection.
INSTALLATION SERVICE POINT
]]A[[ KNOCK SENSOR INSTALLATION
Set the connector of the knock sensor to the area shown in the figure, and tighten the knock sensor to the specified torque.
Tightening torque: 20 ± 2 N.m (15 ± 1 ft-lb)