P1247

DTC P1247: CVT Plausibility

TECHNICAL DESCRIPTION

Checks for an abnormal signal of TCM.

DTC SET CONDITIONS

Check Condition

- Ignition switch is "ON" position.
Judgment Criterion

- A torque demand signal from TCM is abnormal.

TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:)

- CVT system failed.

- ECM failed.

DIAGNOSIS

Required Special Tools:

- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.

- MB991827: USB Cable

- MB991910: Main Harness A

STEP 1. Using scan tool MB991958, read the diagnostic trouble code (DTC).





CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK"
(OFF) position before connecting or disconnecting scan tool MB991958.

(1)Connect scan tool MB991958 to the data link connector.
(2)Turn the ignition switch to the "ON" position.
(3)Read the CVT-DTC.
(4)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is the CVT-DTC set?

YES Diagnostic Trouble Code Chart.

NO Go to Step 2 .

STEP 2. Using scan tool MB991958, read the diagnostic trouble code
(DTC).

(1)Turn the ignition switch to the "ON" position.

(2)After the DTC has been deleted, read the DTC again.

(3)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is DTC P1247 set?

YES Replace the ECM. When the ECM is replaced, register the ID code. Refer to ID registration procedure manual - ID codes registration judgement table [Vehicles with KOS] or ID registration procedure manual - ID codes registration judgement table [Vehicles with WCM].
NO It can be assumed that this malfunction is intermittent. How to Cope With Intermittent Malfunctions.