Power Steering Line/Hose: Service and Repair

REMOVAL AND INSTALLATION





















REMOVAL SERVICE POINT

[[A]] HEAT PROTECTOR/ PRESSURE HOSE ASSEMBLY/ RETURN TUBE ASSEMBLY/ RETURN TUBE REMOVAL

Remove the heat protector, and push the engine assembly and transaxle assembly toward the front of the vehicle to widen the clearance. Then, remove the pressure hose assembly and the return tube.

NOTE:

- When pushing the engine assembly and transaxle assembly, check that the propeller shaft assembly, front exhaust pipe, front roll stopper, and center member assembly are already removed.

INSTALLATION SERVICE POINTS

]]A[[ RETURN HOSE/ HOSE CLAMP/ CLIP INSTALLATION





1. Align the marking as shown in the figure and connect the return hose.





2. Align the return hose marking within the area shown in the figure and connect the return hose.





3. Using clip and hose clamp align the return hose marking within the area shown in the figure and connect the return hose.

]]B[[ RETURN HOSE INSTALLATION





1. Align the marking as shown in the figure and connect the return hose.

]]C[[ PRESSURE HOSE ASSEMBLY INSTALLATION





Align the pressure hose plate as shown in the figure and connect pressure hose assembly.

]]D[[ SUCTION HOSE INSTALLATION





1. Align the oil reservoir side suction hose marking within the area shown in the figure and connect the suction hose.









2. Align the oil pump side suction hose marking within the area shown in the figure and connect the suction hose.