DTC 23

DTC 23: ECM and Its Related Component

DTC SET CONDITIONS

This DTC is set when there is failure in the ECM and its related components.

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CASE:)

- Malfunction of the MFI system.

- Malfunction of the ECM.

DIAGNOSIS

Required Special Tools:

- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.

- MB991827: M.U.T.-III USB Cable

- MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, read the MFI system diagnostic trouble code.





(1)
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

Connect scan tool MB991958 to the data link connector (Refer to Reading and Clearing Diagnostic Trouble Codes).
(2)Turn the ignition switch to the "ON" position.
(3)Check for MFI system diagnostic trouble code Reading and Clearing Diagnostic Trouble Codes) [2.4L Engine] or Monitors, Trips, Drive Cycles and Readiness Codes) [3.0L Engine].
(4)Turn the ignition switch to the "LOCK" (OFF) position.
(5)Disconnect scan tool MB991958.

Q. Is any DTC set?

YES Diagnose the MFI system Multiport Fuel Injection (MFI)) [2.4L Engine] or Multiport Fuel Injection (MFI)) [3.0L Engine]. Then go to Step 3.

NO Go to Step 2.

STEP 2. Read the cruise control system diagnostic trouble code.

(1)Erase diagnostic trouble code. (Refer to Reading and Clearing Diagnostic Trouble Codes).

(2)Turn the ignition switch to the "ON" position, and press the "ON/OFF" switch to turn the cruise control system to ON (turn on the "CRUISE" indicator light).

(3)After turning the cruise control system to ON, when 2 minutes or more has elapsed without operating the cruise control switches, read the diagnostic trouble code of the cruise control system (Refer to Reading and Clearing Diagnostic Trouble Codes).

Q. Is DTC 23 set?

YES Replace the ECM [ Removal and Replacement] [2.4L Engine] or [ Removal and Replacement] [3.0L Engine]. Then go to Step 3.
NO It can be assumed that this malfunction is intermittent How to Cope With Intermittent Malfunctions).
STEP 3. Read the cruise control system diagnostic trouble code.

(1)Erase diagnostic trouble code. (Refer to Reading and Clearing Diagnostic Trouble Codes).

(2)Turn the ignition switch to the "ON" position, and press the "ON/OFF" switch to turn the cruise control system to ON (turn on the "CRUISE" indicator light).

(3)After turning the cruise control system to ON, when 2 minutes or more has elapsed without operating the cruise control switches, read the diagnostic trouble code of the cruise control system (Refer to Reading and Clearing Diagnostic Trouble Codes).

Q. Is DTC 23 set?

YES Return to Step 1.
NO The procedure is complete.