Second Seat Assembly Disassembly and Reassembly

DISASSEMBLY AND ASSEMBLY

[SECOND SEAT (LH)]









DISASSEMBLY SERVICE POINTS

[[A]] HEAD RESTRAINT GUIDE REMOVAL





Remove while pressing the claws on the both sides.

[[B]] ARMREST REMOVAL





Tilt the armrest slightly, and remove it by lifting the left side.

[[C]] SEAT BELT BOLT REMOVAL





Turn up the cushion pad and remove the seat belt bolts.

[SECOND SEAT (RH)]









DISASSEMBLY SERVICE POINT

[[A]] HEAD RESTRAINT GUIDE REMOVAL





Remove while pressing the claws on the both sides.

[SEAT FRAME ASSEMBLY]









DISASSEMBLY SERVICE POINT

[[A]] REMOVAL OF SLIDE LOCK RELEASE CABLE FOR AUTOMATIC TUMBLE MECHANISM









Put a mark in the position shown in view A to record the protrusion of the screw.

REASSEMBLY SERVICE POINTS

]]A[[ REAR POWER SEAT MOTOR INSTALLATION

















1. When installing the rear power seat motor, install the cable as shown in view A.
2. Pass the cable between the frame and the seat rail as shown in view B.
3. Fit the tip of the cable to the second recess of the clamp as shown in view C.

]]B[[ SEAT SLIDE CABLE INSTALLATION













Fit the second recess of the clamp in view A and view B to the bracket. When installing the cable, make sure that the cable is not bitten by the moving area.

]]C[[ SLIDE LOCK RELEASE CABLE FOR AUTOMATIC TUMBLE MECHANISM INSTALLATION













1. When installing the cable in view A, protrude the screws to the position marked during the removal. Then, tumble the seatback and check that the slide locks on the right and left side are fully released. When installing the cable, install the cable with the green marking to the left rail.
2. Fit the second recess of the clamp (yellow) shown in view B to the bracket. Pass the cable between the brackets when installing it. Make sure that the cable is not bitten by the moving area.

]]D[[ SEAT RAIL REAR END LATCH RELEASE CABLE INSTALLATION













Fit the second recess of the clamp in view A to the bracket. When installing the cable, make sure that the cable is not bitten by the moving area. When installing the cable in view B, install the cable with the red marking to the left rail.

]]E[[ TUMBLE LOCK RELEASE CABLE INSTALLATION

















Install the cable as shown in view A. Fit the second recess of the clamp in view A and view B to the bracket. When installing the cable, make sure that the cable is not bitten by the moving area.

]]F[[ SEATBACK LOCK RELEASE CABLE INSTALLATION

















Install the cable as shown in view A. Fit the second recess of the clamp in view B to the bracket. When installing the cable, make sure that the cable is not bitten by the moving area.