Rear Suspension

REMOVAL AND INSTALLATION

CAUTION:

- The parts indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb weight condition.

- The parts indicated by *2 are the bolts/nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.









[2.4L Engine: 5 persons seat]










[2.4L Engine: 7 persons seat, 3.0L Engine]






REMOVAL SERVICE POINTS

[[A]] CONTROL LINK REMOVAL





Make a mating mark on the toe adjusting bolt, and remove the control link.

INSTALLATION SERVICE POINTS

]]A[[ UPPER ARM INSTALLATION





Install the upper arm so that the hole faces the body side.