P1247

DTC P1247: A/T Plausibility

TECHNICAL DESCRIPTION

Checks for an abnormal signal of transmission control module.

DTC SET CONDITIONS

Check Condition

- Ignition switch is "ON" position.
Judgment Criterion

- A torque demand signal from TCM is not normal.

TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:)

- Automatic transaxle system failed.

- ECM failed.

DIAGNOSIS

Required Special Tools:

- MB991958: Scan Tool (M.U.T.-III Sub Assembly)

- MB991824: V.C.I.

- MB991827: USB Cable

- MB991910: Main Harness A

STEP 1. Using scan tool MB991958, read the diagnostic trouble code (DTC).





CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK"
(OFF) position before connecting or disconnecting scan tool MB991958.

(1)Connect scan tool MB991958 to the data link connector.
(2)Turn the ignition switch to the "ON" position.
(3)Read the A/T-DTC.
(4)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is the A/T-DTC set?

YES Super All Wheel Control (S-AWC).

NO Go to Step 2 .

STEP 2. Using scan tool MB991958, read the diagnostic trouble code
(DTC).

(1)Turn the ignition switch to the "LOCK" (OFF) position.

(2)After the DTC has been deleted, read the DTC again.

(3)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is DTC P1247 set?

YES Replace the ECM. When the ECM is replaced, register the ID code. Refer to ID registration procedure manual - ID codes registration judgement table [Vehicles with KOS] or ID registration procedure manual - ID codes registration judgement table [Vehicles with WCM].
NO It can be assumed that this malfunction is intermittent. How to Cope With Intermittent Malfunctions.