P1706

DTC P1706: Accelerator Pedal Position Information

DESCRIPTIONS OF MONITOR METHODS

- When approx. 1 second has elapsed after TCM started, the throttle pedal position signal seizure is detected for 3 seconds.

MONITOR EXECUTION

- Continuous

MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)

- P0712: Malfunction of the transmission fluid temperature sensor (Short circuit)

- P0715: Malfunction of the Input shaft speed sensor system
Sensor (The sensor below is determined to be normal)

- Transmission fluid temperature sensor

- Input shaft speed sensor

LOGIC FLOW CHARTS (Monitor Sequence)





DTC SET CONDITIONS

Check Conditions

- TCM is started: more than 1.05 seconds.
Judgement Criteria

- Accelerator pedal position sensor signal: fail. (3 seconds)

OBD-II DRIVE CYCLE PATTERN

With the ignition switch ON, maintain the status for 10 seconds or more.

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CODE TO BE SET ARE:)

- Malfunction of the CAN

- Malfunction of the ECM

- Damaged harness or connector

- Malfunction of the throttle position sensor

DIAGNOSIS

STEP 1. Is the DTC code for ECM displayed?

Check that the failure related to the engine does not occur.

Q. Is the check result normal?

YES Go to Step 2.
NO Repair or replace the failure section.
STEP 2. Check the throttle position sensor and ECM-side main unit and connector wiring.

Q. Is the check result normal?

YES Go to Step 3.
NO Repair or replace the failure section.
STEP 3. Erase the DTC code, and drive the vehicle for a while.

Check that the normal code is displayed.

Q. Is the check result normal?

YES The procedure is complete.
NO Return to START.