Removal and Replacement

REMOVAL AND INSTALLATION





















REMOVAL SERVICE POINTS

[[A]] TRANSAXLE ASSEMBLY UPPER PART COUPLING BOLT REMOVAL

Only loosen the bolts from the engine and transaxle assembly (do not remove).

[[B]] TORQUE CONVERTER AND DRIVE PLATE COUPLING BOLT REMOVAL

1. Remove the coupling bolts while turning the crankshaft.

2. Fully push the torque converter into the transaxle side so that it does not remain on the engine side.

[[C]] TRANSAXLE MOUNTING BRACKET REMOVAL

1. Place a garage jack against the transaxle case with a piece of wood in between to support the engine and transaxle assembly.

2. Operate a garage jack so that the weight of the engine and transaxle assembly is not applied to the transaxle mounting insulator, and remove the transaxle mounting bracket.

[[D]] ENGINE ASSEMBLY HOLDING









1.
CAUTION:
The engine hanger plate (special tool: MB992208)should be secured by tightening bolts with the engine hanger plate to the specified torque (If the other bolts are used, the engine assembly may fall down when it is raised.)

Tightening torque: 22 ± 4 Nm (16 ± 2 ft-lb)

Remove the intake manifold plenum stay, rear on the right bank and the engine hanger on the left bank, and then install the engine hanger plate (Special tool: MB992208) to the place.









2. When engine hanger (Special tool: MB991928) is used
(1) Assemble the engine hanger (Special tool: MB991928). (Set the components below to the base hanger.)

- Slide bracket (HI)

- Foot x 2 (standard) (MB991932)

- Foot x 2 (short) (MB991933)

- Joint x 2 (90) (MB991930)
(2)
Set the feet of the special tool as shown in the figure.
NOTE:
Adjust the engine hanger balance by sliding the slide bracket (HI).

(3) Set the chains of the engine hanger (Special tool: MB991527) and the engine hanger balancer
(Special tool: MB991454) to support the engine and transaxle assembly. Remove the garage jack and then remove the transaxle assembly upper part coupling bolts that have been loosened previously.













3. When using engine mechanical hanger (Special tool: MB991895)
(1) Set the foot of the engine mechanical hanger (Special tool: MB991895) as shown in the figure.
NOTE:
Slide the front foot of the engine mechanical hanger (Special tool: MB991895) to balance the engine hanger.

CAUTION:
Place rag between the engine mechanical hanger (Special tool: MB991895) and the windshield to prevent the special tool from interfering with the windshield.

(2) Set the chains of the engine hanger (Special tool: MB991527) and the engine hanger balancer (Special tool: MB991454) to support the engine and transaxle assembly.
Remove the garage jack and then remove the transaxle assembly upper part coupling bolts that have been loosened previously.

INSTALLATION SERVICE POINTS

]]A[[ TRANSAXLE ASSEMBLY INSTALLATION





Fully push the torque converter into the transaxle side, and then assemble the transaxle assembly to the engine.

]]B[[ TRANSAXLE MOUNTING INSULATOR STOPPER INSTALLATION





Install the transaxle mounting insulator stopper as shown in the figure.

]]C[[ TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE) INSTALLATION





1. Move the selector lever and manual control lever to the "N" position.
2. Use the adjusting nut to tighten the transaxle control cable to the specified torque.
Tightening torque: 9.5 ± 3.5 Nm (84 ± 30 in-lb)