Electronic Control Coupling Solenoid (Center) Check [Vehicles with S-AWC]

ELECTRONIC CONTROL COUPLING SOLENOID (CENTER) CHECK [VEHICLES WITH S-AWC]





1. Disconnect the D-138 connector, and measure the resistance value between the connector terminals on the electronic control coupling side. If the measured resistance value is out of the standard value range, replace the electronic control coupling (Refer to Service and Repair).
Standard value: 1.6 - 3.7 ohms
2. Measure the resistance value between the connector terminal No.1 on the electronic control coupling side and the body ground. If the continuity exists, replace the electronic control coupling (Refer to Service and Repair).