Inspection Procedure 10

INSPECTION PROCEDURE 10: The select shock is large when the transmission range is shifted from "N" to "D", and "N"
to "R."

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CONDITION:)

- Malfunction of the engine: Idle speed

- Poor adjustment of transmission range switch

- Malfunction of the TCM

- A/T failure: Hydraulic system (valve body assembly), driving force transmission system (clutch/brake)

DIAGNOSIS

STEP 1. Check the engine performance.

Especially check that the idle speed does not exceed the specified value.

Q. Is the check result normal?

YES Go to Step 2.
NO Repair the failure, and perform adjustment.
STEP 2. Check and adjust the transmission range switch.

Refer to Testing and Inspection, Adjustments.

If the transmission range switch has a failure, replace it, and then check the trouble symptom again.

Q. Is the check result normal?

YES The procedure is complete.
NO Go to Step 3.
STEP 3. Replace the TCM.

Q. Is the failure resolved?

YES The procedure is complete.
NO Go to Step 4.
STEP 4. Compare with another same model vehicle.

Q. Is there a difference from the same model vehicle?

YES Go to Step 5.
NO The procedure is complete.
STEP 5. Remove the transaxle assembly from the vehicle.

Disassemble and check the transaxle assembly to check if there is a foreign material inside.

Q. Is the check result satisfactory?

YES Replace the transaxle assembly.
NO Replace the failure part.