Inspection Procedure 12
INSPECTION PROCEDURE 12: Abnormal sound occurs during driving.
TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CONDITION:)
- Engine- and body-related failures: Abnormal sound of auxiliary parts, drive shaft, wheel bearing
- Installation of non-genuine aeroparts to the body
- Abnormal incoming route of sound: Installation of transaxle control cable, damping device, sound isolation device
- Malfunction of the torque converter
- A/T failure: Driving force transmission system (gear), hydraulic system
(valve body assembly, hydraulic circuit)
NOTE:
Inspection items for abnormal sound
1. Check of sound source and incoming route (radiated sound, propagation sound, resonance, etc.), and measurement at driver's seat, front passenger's seat, and rear passenger's seat
2. Change of sound during cold and after warm up (Change of fluid, and hydraulic pressure)
3. Change of sound with the engine speed (r/min order change)
4. Change of sound with the vehicle speed (r/min order change, wind noise)
5. Change of sound with the throttle valve opening (engine output change, hydraulic pressure change)
DIAGNOSIS
STEP 1. Check the body and engine performance.
- Check if a non-genuine aeropart is installed to the body.
- Check the engine auxiliary parts, drive shaft, and wheel bearing.
- Check if the abnormal sound changes in accordance with the engine speed, or the vehicle speed.
Q. Is the check result normal?
YES Go to Step 2.
NO Repair the failure, and perform adjustment.
STEP 2. Check the installation of the transaxle control cable, damping device, and sound isolation device.
Q. Is the check result normal?
YES Go to Step 3.
NO Repair the failure, and perform adjustment.
STEP 3. Check the abnormal sound.
Q. Does the abnormal sound change in accordance with the vehicle speed?
YES Go to Step 5.
NO Go to Step 4.
STEP 4. Check the abnormal sound.
Q. Does the abnormal sound change in accordance with the throttle valve opening? Or is it the transmission fluid sound especially caused at start-up?
YES Replace the torque converter.
NO Go to Step 5.
STEP 5. Compare with another same model vehicle.
Q. Is there a difference from the same model vehicle?
YES Go to Step 6.
NO The procedure is complete.
STEP 6. Remove the transaxle assembly from the vehicle.
Disassemble and check the transaxle assembly to check if there is a foreign material inside.
Q. Is the check result satisfactory?
YES Replace the transaxle assembly.
NO Replace the failure part.