Inspection Procedure 2

INSPECTION PROCEDURE 2: The vehicle does not run at the "D" or the "R" range.

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CONDITION:)

- Poor adjustment of transaxle control cable

- A/T failure: Hydraulic system (valve body assembly), driving force transmission system (clutch/brake)

DIAGNOSIS

STEP 1. Check the transaxle control cable.

Check the installation status of transaxle control cable and transmission range switch.

Q. Is the check result normal?

YES Go to Step 2.
NO Adjust the installation status of transaxle control cable and transmission range switch. Adjustments.
STEP 2. Check the transmission fluid.

Check the transmission fluid for seizure, fouling, and level.

Q. Is the check result normal?

YES The procedure is complete.
NO Go to Step 3.
STEP 3. Remove the transaxle assembly from the vehicle.

Disassemble and check the transaxle assembly to check if there is a foreign material inside.

Q. Is the check result satisfactory?

YES Replace the transaxle assembly.
NO Replace the failure part.