Inspection Procedure 4

INSPECTION PROCEDURE 4: The vehicle moves at the "N" range.

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CONDITION:)

- Poor adjustment of transaxle control cable

- A/T failure: Hydraulic system (valve body assembly), driving force transmission system (clutch/brake)

DIAGNOSIS

STEP 1. Check the engine performance.

Q. Is the check result normal?

YES Go to Step 2.
NO Repair the failure, and perform adjustment.
STEP 2. Compare with another same model vehicle.

Q. Is there a difference from the same model vehicle?

YES Go to Step 3.
NO The procedure is complete.
STEP 3. Check the transaxle control cable.

Check the installation status of transaxle control cable and transmission range switch.

Q. Is the check result normal?

YES Go to Step 4.
NO Adjust the installation status of transaxle control cable and transmission range switch. Refer to Adjustments.
STEP 4. Check the transmission fluid.

Check the transmission fluid for seizure, fouling, and foreign material.

Q. Is the check result normal?

YES The procedure is complete.
NO Go to Step 5.
STEP 5. Remove the transaxle assembly from the vehicle.

Disassemble and check the transaxle assembly to check if there is a foreign material inside.

Q. Is the check result satisfactory?

YES Replace the transaxle assembly.
NO Replace the failure part.