Electrical Power Steering System (EPS)

DTC U1415 Variant coding not implemented

CAUTION:

- If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines CAN Bus Diagnostics Chart ).
- Whenever ECU is replaced, ensure that the CAN bus lines are normal.

OPERATION

- EPS-ECU receives variant coding data from the ETACS-ECU.

FUNCTION

- The coding data is sent to the EPS-ECU for motor control.

TROUBLE JUDGEMENT

Check Conditions

- The power supply circuit system DTCs C1540, C1541 is not set.
- The ETACS circuit system DTC is not set.

Judgement Criterion

- The EPS-ECU coding is not completed.
- The coding data is not sent from the ETACS-ECU, and the microcomputer determines that there is a problem in the system.

Fail Safe, Back Up Function

- The EPS-ECU stops the motor control, then sets the DTC U1415.

PROBABLE CAUSES

- Malfunction of CAN bus line
- Malfunction of the EPS-ECU
- Malfunction of the ETACS-ECU

DIAGNOSIS

STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.

Use scan tool to diagnose the CAN bus lines.

Q. Is the check result normal?

YES Go to Step 2.
NO Repair the CAN bus lines CAN Bus Diagnostics Chart).
On completion, go to Step 4.
STEP 2. Using scan tool MB991958, check the other system DTC.

Use scan tool to check that the DTC B222C is set in the ETACS-ECU.

Q. Is any DTC set?

YES Troubleshoot the relevant DTC, and then go to Step 4.
NO Go to Step 3.
STEP 3. DTC recheck after resetting CAN bus lines

(1)Erase the DTC.

(2)Turn the ignition switch from "LOCK" (OFF) to "ON" and hold it for 1 minute, and turn it from "ON" to "LOCK" (OFF) and hold it for 1 minute. Then, turn the ignition switch from "LOCK"
(OFF) to "ON".

(3)Check if the DTC is set.

Q. Is the DTC U1415 set?

YES Go to Step 4.
NO This diagnosis is complete.
STEP 4. Check whether the DTC is reset.

(1)Erase the DTC.

(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.

(3)Check if the DTC is set.

Q. Is the DTC U1415 set?

YES Replace the EPS-ECU (Refer to Service and Repair).Then go to Step 5
NO Intermittent malfunction How to Cope With Intermittent Malfunctions.
STEP 5. Check whether the DTC is reset.

(1)Erase the DTC.

(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.

(3)Check if the DTC is set.

Q. Is the DTC U1415 set?

YES Return to Step 1.
NO This diagnosis is complete.