Case Components

1. Remove check ball plug, check spring and check ball. Then remove interlock stopper.
- If interlock assembly is removed as a unit, the check ball can fall into transmission case.
- Be careful not to lose check ball.




2. Remove control housing return spring and check ball.
- Be careful not to lose check ball.




3. Drive out retaining pin from striking arm.




4. Remove rear extension (or OD gear case) together with striking arm by tapping lightly.




5. Remove front cover and gasket.




6. Remove stopper ring and main drive bearing snap ring.




7. Remove transmission case by tapping lightly.




8. Remove front cover oil seal.