With Transmitter Activation Tool

ID REGISTRATION WITH TRANSMITTER ACTIVATION TOOL
This procedure must be done after replacement of a low tire pressure warning transmitter or BCM.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected during self-diagnosis depending on control unit which carries out CAN communication.

1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.

2. Select "START (NISSAN BASED VHCL)".

3. Touch "BCM" on "SELECT SYSTEM" screen.

NOTE: If "BCM" is not indicated, go to "CAN COMMUNICATION" .

4. Select "AIR PRESSURE MONITOR" on "SELECT TEST ITEM" screen.

5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".

6. With the transmitter activation tool (J-45295) pushed against the front left transmitter position of the tire air valve, press the button for 5 seconds.

Tool number : - (J-45295)





7. Register the IDs in order from FR LH, FR RH, RR RH and RR LH. When ID registration of each wheel has been completed, a buzzer sounds and the warning lamp flashes.





8. After completing all ID registrations, press "END" to complete the procedure.

NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.