Without Transmitter Activation Tool

ID REGISTRATION WITHOUT TRANSMITTER ACTIVATION TOOL
This procedure must be done after replacement of a low tire pressure warning transmitter or BCM.
1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.
2. Select "START (NISSAN BASED VHCL)".
3. Touch "BCM" on "SELECT SYSTEM" screen.

NOTE: If "BCM" is not indicated, go to LAN-22, "CAN COMMUNICATION". CAN Communication

4. Select "AIR PRESSURE MONITOR" on "SELECT TEST ITEM" screen.
5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".





6. Adjust the tire pressure to the values shown in the table for ID registration, and drive the vehicle at 15 km/h (9.4 MPH) or more for a few minutes.





7. After completing all ID registrations, press "END" to complete the procedure.
8. Inflate all tires to proper pressure. Refer to "Tire".