Brake Signal Circuit

BRAKE SIGNAL CIRCUIT

CONSULT-II Reference Value:

Diagnostic Procedure
1. CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to AT-90, SELF-DIAGNOSTIC RESULT MODE. Self-Diagnostic Result Mode
Is a malfunction in the CAN communication indicated in the results?
YES >> Check CAN communication line.
NO >> GO TO 2.

2. CHECK STOP LAMP SWITCH CIRCUIT

With CONSULT-II





1. Turn ignition switch ON. (Do not start engine.)
2. Select ECU INPUT SIGNALS in DATA MONITOR mode for A/T with CONSULT-II.
3. Read out ON/OFF switching action of the BRAKE SW.
OK or NG
OK >> INSPECTION END
NG >> GO TO 3.

3. CHECK STOP LAMP SWITCH





Check continuity between stop lamp switch harness connector terminals 1 and 2.





Check stop lamp switch after adjusting brake pedal.
OK or NG
OK >> Check the following. If NG, repair or replace damaged parts.
^ Harness for short or open between battery and stop lamp switch.
^ Harness for short or open between stop lamp switch and combination meter.
NG >> Repair or replace the stop lamp switch.