C1179

Delta Stroke Sensor System Inspection

INSPECTION PROCEDURE
1.DISPLAY SELF DIAGNOSIS RESULTS
Check self-diagnosis results.





Is the above displayed in the self-diagnosis display items?
YES or NO
YES - GO TO 2.
NO - Inspection End.

2.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the delta stroke sensor connector E114 and ABS actuator and electric unit (control unit) connector E125 and inspect the terminals for deformation, disconnection, looseness, or damage.
OK or NG
OK - GO TO 3.
NG - Repair connector.

3.DELTA STROKE SENSOR CIRCUIT INSPECTION
1. Measure the continuity between the ABS actuator and electric unit (control unit) connector E125 and delta stroke sensor connector E114.





2. Measure the continuity between the ABS actuator and electric unit (control unit) connector E125 and body ground.





OK or NG
OK - GO TO 4.
NG - Repair or replace harness or connector.

4.DELTA STROKE SENSOR INSPECTION
1. Reconnect the delta stroke sensor and ABS actuator and electric unit (control unit) connectors.
2. Use "DATA MONITOR" to check if the status of "DELTA S SEN" is normal.





OK or NG
OK - Inspection End.
NG - Replace delta stroke sensor.