Engine - Overheating/Condenser Fan Inoperative

Classification:
EL07-015

Reference:
NTB07-027

Date:
May 3, 2007

2007 TITAN AND ARMADA; ENGINE OVERHEATS AND/OR
CONDENSER FAN IS INOPERATIVE

APPLIED VEHICLES:
2007 Titan (A60)
2007 Armada (TA60)

APPLIED VINs:
Titan built before 1N6(*)A0(***)7N224874
Armada built before 5N1AA08(**)7N 715024

APPLIED DATE
Built before December 20, 2006

IF YOU CONFIRM
The engine is overheating under normal driving conditions and the engine cooling system is operating correctly,

and/or

The condenser fan is inoperative,

and/or

Poor A/C performance when there is high outside temperature and the condenser fan is running.

ACTIONS





1. Make sure the condenser fan does not already have a jumper harness installed (see Jumper Harness installation).

^ If a jumper harness is already installed, this bulletin does not apply.

2. Replace the condenser fan.

3. Install a jumper harness onto the condenser fan.

IMPORTANT:
The purpose of "ACTIONS (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service Procedure as it contains information that is essential to successfully completing the repair.





PARTS INFORMATION

CLAIMS INFORMATION





Submit a CM line claim using the following claims coding:

"CM" I.D.: P7215

SERVICE PROCEDURE

1. Make sure the condenser fan does not already have a jumper harness installed (see Jumper Harness installation on page 3).

^ If a jumper harness is already installed, this bulletin does not apply. Go to AS 1ST for further diagnostic and repair information.





2. Replace the engine cooling fan-motor driven type (condenser fan).

^ Refer to section CO in the Service Manual for fan replacement information.

^ During condenser fan replacement, install the jumper harness as shown.

3. Make sure the incident is fixed.

Jumper Harness Installation





A. Make sure the jumper harness Part Number is 24167 - ZJ5OA.

B. Connect the new jumper harness as shown.





NOTE:
Make sure only one jumper harness is installed as shown.





C. Mount the connector in the 4th hole as shown.





Disclaimer