High-Pressure Pipe
Exploded View ATC-186 (Part 1):
Exploded View ATC-186 (Part 2):
Components
Removal and Installation for High-pressure Pipe
REMOVAL
1. Disconnect the battery negative terminal and battery positive terminal.
2. Reposition the IPDM E/R aside.
3. Remove the front right wheel and tire assembly.
4. Position aside the front floor insulator.
5. Discharge the refrigerant. Refer to "HFC-134a (R-134a) Service Procedure".
6. Remove the low pressure pipe.
7. Remove the high-pressure pipe.
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
INSTALLATION
Installation is in the reverse order of removal.
Refer to Exploded View ATC-186.
CAUTION:
- Replace the O-ring of the high-pressure pipe with a new one, then apply compressor oil to it when installing it.
- After charging refrigerant, check for leaks.