Low-Pressure Flexible Hose
Exploded View ATC-186 (Part 1):
Exploded View ATC-186 (Part 2):
Components
Removal and Installation for Low-pressure Flexible Hose
REMOVAL
1. Remove the engine room cover using power tool.
2. Remove the engine air cleaner and air ducts.
3. Discharge the refrigerant. Refer to "HFC-134a (R-134a) Service Procedure".
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
4. Remove the low-pressure flexible hose.
INSTALLATION
Installation is in the reverse order of removal.
Refer to Exploded View ATC-186.
CAUTION:
- Replace the O-ring of the low-pressure flexible hose with a new one, then apply compressor oil to it when installing it.
- After charging refrigerant, check for leaks.