Door Mirror Remote Control Switch (Mirror Switch) Circuit Inspection

AUTOMATIC DRIVE POSITIONER


Door Mirror Remote Control Switch (Mirror Switch) Circuit Inspection

1.CHECK DOOR MIRROR SWITCH (MIRROR SWITCH) SIGNAL
With CONSULT-III
Check the operation on "MIR CON SW-UP/DN" and "MIR CON SW-RH/LH" in the DATA MONITOR.





Without CONSULT-III





1. Turn ignition switch to ACC.
2. Check voltage between automatic drive positioner control unit connector and ground.











OK or NG
OK - Door mirror remote control switch (mirror switch) circuit is OK.
NG - GO TO 2.
2.CHECK HARNESS CONTINUITY





1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror remote control switch.
3. Check continuity between automatic drive positioner control unit connector M41 (A) terminals 3, 4, 19, 20 and door mirror remote control switch connector D10 (B) terminals 1, 2, 3, 4.






4. Check continuity between automatic drive positioner control unit connector M41 (A) terminals 3, 4, 19, 20 and ground.





OK or NG
OK - GO TO 3.
NG - Repair or replace harness.
3.CHECK DOOR MIRROR REMOTE CONTROL SWITCH (MIRROR SWITCH)





Check continuity between door mirror remote control switch terminals as follows.






OK or NG
OK - Check the condition of the harness and connector.
NG - Replace door mirror remote control switch.