Sliding Switch Circuit Inspection

AUTOMATIC DRIVE POSITIONER


Sliding Switch Circuit Inspection

1.CHECK FUNCTION
With CONSULT-III
With "SLIDE SW-FR, SLIDE SW-RR" on the DATA MONITOR, operate the sliding switch to check ON/OFF operation.





Without CONSULT-III





1. Turn ignition switch OFF.
2. Check voltage between driver seat control unit connector and ground.






OK or NG
OK - Sliding switch circuit is OK.
NG - GO TO 2.
2.CHECK SLIDING SWITCH CIRCUIT HARNESS CONTINUITY





1. Disconnect driver seat control unit connector and power seat switch LH connector.
2. Check continuity between driver seat control unit connector B401 terminals 11, 26 and power seat switch LH connector B407 terminals 1, 7.






3. Check continuity between driver seat control unit connector B401 terminals 11, 26 and ground.





OK or NG
OK - GO TO 3.
NG - Repair or replace harness.
3.CHECK SLIDING SWITCH





Check continuity between power seat switch LH terminals as follows.





OK or NG
OK - Check the condition of the harness and connector.
NG - Replace power seat switch LH. Refer to Removal And Installation.