Front Door Lock Assembly LH (Key Cylinder Switch) Check
POWER DOOR LOCK SYSTEM
Front Door Lock Assembly LH (Key Cylinder Switch) Check
1.CHECK DOOR KEY CYLINDER SWITCH LH
With CONSULT-III
Check front door lock assembly LH (key cylinder switch) ("KEY CYL LK-SW") and ("KEY CYL UN-SW) in DATA MONITOR mode in CONSULT�III. Refer to CONSULT-III Function (BCM).
- When key inserted in front key cylinder is turned to LOCK:
KEY CYL LK-SW : ON
- When key inserted in front key cylinder is turned to UNLOCK:
KEY CYL UN-SW : ON
Without CONSULT-III
Check voltage between main power window and door lock/unlock switch connector D7 terminals 6, 7 (without automatic sliding door system) or terminals 4, 6 (with automatic sliding door system) and ground.
Without Automatic Sliding Door System
With Automatic Sliding Door System
OK or NG
OK - Front door lock assembly LH (key cylinder switch) signal is OK.
NG - GO TO 2.
2.CHECK DOOR KEY CYLINDER SWITCH LH GROUND HARNESS
1. Turn ignition switch OFF.
2. Disconnect front door lock assembly LH (key cylinder switch).
3. Check continuity between front door lock assembly LH (key cylinder switch) connector D14 terminal 5 and body ground.
OK or NG
OK - GO TO 3.
NG - Repair or replace harness.
3.CHECK DOOR KEY CYLINDER SWITCH LH
Check continuity between front door lock assembly LH (key cylinder switch) terminals.
OK or NG
OK - GO TO 4.
NG - Replace front door lock assembly LH (key cylinder switch). Refer to Locations Service and Repair.
4.CHECK DOOR KEY CYLINDER HARNESS
Check continuity between main power window and door lock/unlock switch connector (A) D7 terminals 6, 7 (without automatic sliding door system) or terminals 4, 6 (with automatic sliding door system) and front door lock assembly LH (key cylinder switch) connector (B) D14 terminals 1, 6 and body ground.
Without Automatic Sliding Door System
With Automatic Sliding Door System
OK or NG
OK - Replace main power window and door lock/unlock switch.
NG - Repair or replace harness.