Mirror Sensor RH Circuit Inspection

AUTOMATIC DRIVE POSITIONER


Mirror Sensor RH Circuit Inspection

1.CHECK DOOR MIRROR FUNCTION
Check the following items.
Operation malfunction in memory control

NOTE:
If a door mirror face position is set to an implausible angle, the set position may not be reproduced.
OK or NG
OK - GO TO 2.
NG - Repair the malfunctioning parts, and check the symptom again.
2.CHECK MIRROR SENSOR INSPECTION
With CONSULT-III
Check that "ON" is displayed on "MIR/SEN RH R-L, MIR/SEN RH U-D" in the DATA MONITOR.





Without CONSULT-III





1. Turn ignition switch to ACC.
2. Check voltage between door mirror RH connector and ground.





OK or NG
OK - Mirror sensor RH is OK.
NG - GO TO 3.
3.CHECK HARNESS CONTINUITY 1





1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror RH.
3. Check continuity between automatic drive positioner control unit connector M42 terminals 33, 41 and door mirror RH connector D107 terminals 5, 8.






4. Check continuity between automatic drive positioner control unit connector M42 terminals 33, 41 and ground.






OK or NG
OK - GO TO 4.
NG - Repair or replace harness.
4.CHECK HARNESS CONTINUITY 2





1. Check continuity between automatic drive positioner control unit connector M41 terminals 5, 21 and door mirror RH connector D107 terminals 6, 7.






2. Check continuity between automatic drive positioner control unit connector M41 terminals 5, 21 and ground.






OK or NG
OK - Replace door mirror actuator RH. Refer to Door Mirror Assembly.
NG - Repair or replace harness.