Pedal Adjusting Sensor Circuit Inspection

AUTOMATIC DRIVE POSITIONER


Pedal Adjusting Sensor Circuit Inspection

1.CHECK FUNCTION
With CONSULT-III
Operate the pedal adjusting switch with "PEDAL SEN" on the DATA MONITOR to make sure the voltage changes.





Without CONSULT-III





1. Turn ignition switch OFF.
2. Check voltage between automatic drive positioner control unit connector and ground.





OK or NG
OK - Pedal adjusting sensor circuit is OK.
NG - GO TO 2.
2.CHECK PEDAL ADJUSTING SENSOR CIRCUIT HARNESS CONTINUITY






1. Disconnect automatic drive positioner control unit and pedal adjusting sensor.
2. Check continuity between automatic drive positioner connector M41, M42 terminals 8, 33, 41 and pedal adjusting sensor connector E110 terminals 1, 2, 3.






3. Check continuity between automatic drive positioner control unit connector M41, M42 terminals 8, 33, 41 and ground.







OK or NG
OK - Replace pedal adjusting motor. Refer to Service and Repair.
NG - Repair or replace harness.