Sunroof / Moonroof: Adjustments

SUNROOF


Fitting Adjustment







GAP AND HEIGHT ADJUSTMENT
If any gap or height difference between glass lid assembly and roof is found, check glass lid assembly fit.
Adjust the sunroof glass lid assembly as follows:
1. Open sunshade, tilt glass lid assembly up and remove side trim.
2. Loosen glass lid assembly screws (2 each on left and right sides), then tilt glass lid assembly down.

NOTE:
To prevent glass lid assembly from moving after adjustment, first gently tighten the glass lid assembly screw at left front, then right rear.
3. For gap adjustments:
- Manually adjust glass lid assembly forward or rearward until gap becomes equal in distance between front and rear of roof panel edge.
4. For height adjustments:
- Manually adjust glass lid assembly up or down from outside of vehicle until it is within the specification "A-A" as shown.
5. After gap/height adjustment, tilt glass lid assembly up and tighten all screws.
6. Tilt mechanism up and down several times to check that it operates smoothly.

NOTE:
After glass lid assembly gap or height adjustments are performed, always cover the entire surface of the roof with water to check for leaks.