Body - Front Door Window Motor Limit Switch Resetting
EL08-031AReference: NTB09-027A
Date: July 15, 2010
FRONT WINDOW REGULATOR MOTOR LIMIT SWITCH RESET
This bulletin has been amended. The APPLIED VEHICLES section has been revised. No other changes have been made. Please discard all previous copies.
APPLIED VEHICLES:
2006-2010 Armada (TA60)
2006-2009 Quest (V42)
2006-2010 Titan (A60)
SERVICE INFORMATION
If any of the following work has been done:
^ removal and installation of the regulator assembly
^ removal and installation of the motor from the regulator
^ installation of a new glass window
^ installation of a new glass run
....check the label on the window motor to see if the part number is one of the following:
^ 80730-ZT01A
^ 80731-ZT01A
^ 80730-ZM70B
^ 80731-ZM70B
NOTE:
The label can be checked with the motor in the vehicle by using a mirror.
If the window motor is listed above, the Limit Switch will need to be reset using the procedure in this bulletin.
NOTE:
Some of the window motors with these part numbers may appear to have a reset switch, but it will not reset the Limit Switch.
SETTING OF LIMIT SWITCH
1. Connect the door harness to the power window motor, and rotate the motor more than 5 turns in the glass raising (up) direction.
^ LH motor: Rotate counterclockwise.
^ RH motor: Rotate clockwise.
2. Install the power window motor onto the regulator.
3. Install the regulator assembly into the door.
4. Secure regulator assembly to door inner with fasteners then install glass into door and attach to regulator.
5. Raise the glass to the top position.
CAUTION:
Do not operate the glass automatically to raise the glass to the top.