Removal and Replacement

HEADLAMP


Removal and Installation


COMBINATION LAMP ASSEMBLY (FRONT)

WARNING:
Do not touch bulb by hand right after being turned off. Burning may result.

CAUTION:
- Turn headlamp switch OFF before disconnecting headlamp harness connector.
- Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from it.
- Do not leave bulb out of combination lamp assembly (front) for a long time because dust, moisture, smoke, etc. may affect the performance of the lamp. When replacing bulb, be sure to replace it with a new one.

Removal
1. Partially remove fender protector (forward edge), Service and Repair.
2. Remove front grille, Service and Repair.





3. Remove the bolts (A), disconnect the electrical connector, and remove the front combination lamp assembly (1).

Installation
Installation is in the reverse order of removal.