Wheel Sensor

WHEEL SENSORS


Removal and Installation







REMOVAL
1. Remove wheel sensor bolt.
- When removing the front wheel sensor, first remove the disc rotor to gain access to the front wheel sensor bolt. Rear.
- When removing the rear wheel sensor, first remove the rear hub and bearing assembly to gain access to the rear wheel sensor bolt. Rear Wheel Hub.
2. Pull out the sensor, being careful to turn it as little as possible.

CAUTION:
- Do not pull on the sensor harness.
3. Disconnect wheel sensor harness electrical connector, then remove harness from attaching points.

INSTALLATION
Installation is in the reverse order of removal. Tighten wheel sensor bolt to specification.

CAUTION:
- Inspect wheel sensor O-ring, replace sensor assembly if damaged.
- Before installing wheel sensor, make sure no foreign materials (such as iron fragments) are adhered to the pick-up part of the sensor, to the inside of the sensor hole or on the rotor mating surface.
- Apply a coat of suitable grease to the wheel sensor O-ring and hole. Fluid Type Specifications.