For Mexico

P1574 ASCD VEHICLE SPEED SENSOR





Description
The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. For Mexico for ASCD functions.




DTC Logic

DTC DETECTION LOGIC

NOTE:
- If DTC P1574 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
- If DTC P1574 is displayed with DTC P0500, first perform the trouble diagnosis for DTC P0500. For Mexico
- If DTC P1574 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. For Mexico
- If DTC P1574 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. For Mexico.






DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
1. Start engine.
2. Drive the vehicle at more than 40 km/h (25 MPH).

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle.
If a road test is expected to be easier, it is unnecessary to lift the vehicle.
3. Check DTC.
Is DTC detected?
YES - Go to For Mexico.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK DTC WITH TCM
Check DTC with TCM. CONSULT-III Function (Transmission).
Is the inspection result normal?
YES - GO TO 2.
NO - Perform trouble shooting relevant to DTC indicated.
2.CHECK DTC WITH "ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)"
ABS (ABS models), VDC/TCS/ABS (VDC models).
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace.
3.CHECK COMBINATION METER
Check combination meter function. CONSULT-III Function.
- INSPECTION END