Without Manual Mode

SHIFT POSITION INDICATOR CIRCUIT


WITHOUT MANUAL MODE : Description

- TCM sends position indicator signals to combination meter via CAN communication line.
- The selector lever position is indicated on the shift position indicator.





SHIFT POSITION INDICATOR CIRCUIT


WITHOUT MANUAL MODE : Diagnosis Procedure

1.CHECK INPUT SIGNALS
With CONSULT-III
1. Start engine.
2. Select "RANGE" in "Data Monitor" and read out the value.
3. Check that correct selector lever position ("P", "R", "N", "D", "L") is displayed as selector lever is shifted into each position.
Is the inspection result normal?
YES - INSPECTION END
NO-1 (CVT position indicator does not indicate "L" when selector lever is shifted into "L".)-Check the following.
- Check overdrive control switch. Component Inspection.
- Check CVT main system (Fail-safe function actuated).
- Perform "Self Diagnostic Results" in "TRANSMISSION".
NO-2 (The actual gear position changes, but the shift position indicator is not indicated.)-Perform "Self
Diagnostic Results" in "TRANSMISSION".
NO-3 (The actual gear position and the indication on the shift position indicator do not coincide.)-Perform "Self Diagnostic Results" in "TRANSMISSION".
NO-4 (Only a specific position or positions is/are not indicated on the shift position indicator.)-Check the combination meter. CONSULT-III Function.