Electrical - Engine Harness Replacement Note
Classification: EL12-034AReference: NTB12-043A
Date: May 18, 2012
2008-2012 ROGUE ENGINE HARNESS REPLACEMENT
This bulletin has been amended. Applied VIN and Applied Date have been added. Please discard previous versions of this bulletin.
APPLIED VEHICLES: 2008-2012 Rogue (S35)
APPLIED VIN: Built on or before JN8AS5M(*)(*)CW 713595
APPLIED DATE: Built on or before March 28, 2012
SERVICE INFORMATION
If for any reason the engine harness is replaced, during the replacement of the harness, install a rubber protective pad on the battery tray support bracket at the location shown in Figure 1 above. Refer to the Service Procedure for installation instructions.
PARTS INFORMATION
SERVICE PROCEDURE
1. Cut the rubber protective pad in half, length wise.
^ Only 1/2 (either half) of the pad will be used.
2. Clean the area where the protective pad will be installed.
^ Installation area is shown with dashed line.
^ Clean both sides of the bracket edge. Pad will be folded over and attached to both sides.
3. Attach the rubber protective pad as shown.
4. Fold the protective pad over the bracket edge so it covers and sticks to both side.
NOTE:
Figure 4 shows the finished installation of the protective pad on both sides of the bracket.