Section 1: Installing the Update MAP Into Assist

SECTION 1: INSTALLING THE UPDATE MAP INTO ASSIST

^ Once the newest version is installed into the Consult PC it can be used to upgrade many HDD navigation systems. It is not necessary to install the updated map each time you perform a map data upgrade.

^ If the newest map data is already installed in the Consult PC, you can skip to Section 2.





1. Connect the DVD drive to the Consult PC with the USB cable.

2. Turn ON the Consult PC.

3. Open / start ASIST.





4. Select Specialty Tools, Then HD Navi. Tools.





5. Select Install Map Update





6. Select Installing updated map

7. Insert the Map Data Master Disc 1 into the DVD drive.





8. Confirm the correct name of the DVD drive is displayed (see Figure 1-5).

^ "E" is likely the correct name for the DVD drive.

^ The DVD drive name may be different depending on the drive configuration of your C-III computer.

9. Select START





^ Installation of the update map will start and a progress screen will display.

^ Installation will take several minutes.





^ At about 35% this message will display as shown above.

^ When you get the above message, remove Disc 1; install Disc 2; then select YES.





^ When installation is complete the screen shown in Figure 1-8 will display.

10. Select OK





11. Select EXIT

12. Remove Disc 2 from the DVD drive.





13. Select the Safely Remove Hardware icon on the "system tray" which is displayed in the bottom right of the Consult PC screen.

^ You may need to click on the "expand arrow" to expand the icon selections.





14. Select "Safely remove USB Mass Storage Device" - Drive (E:)

^ The drive name will likely be E, but may be different depending on the drive configuration of your Consult PC.





15. Disconnect the DVD drive from the Consult PC.