Without Intelligent Key System

REAR DOOR LOCK

Removal and Installation


REMOVAL

1.Remove the rear door finisher. Service and Repair.
2.Remove the inner seal.
3.Remove door grommets, and remove outside handle nuts from the hole.
4.Remove outside handle.
5.Disconnect the outside handle cable connection.
6.Remove the inside door handle.
7.Disconnect the door lock and inside door handle cables from the inside door handle.
8.Disconnect the door lock actuator connector and remove the assembly.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
Do not twist the outside door handle cable, inside door handle cable and door lock cable during installation.