Type 2
SLIP INDICATOR LAMP
Description
Component Function Check
1. CHECK SLIP INDICATOR LAMP OPERATION
Check that the lamp illuminates for approximately 2 seconds after the ignition switch is turned ON.
Is the inspection result normal?
YES- Inspection End.
NO- Go to diagnosis procedure. .
Diagnosis Procedure
1. CHECK SELF-DIAGNOSIS
Perform ABS actuator and electric unit (control unit) self-diagnosis. Type 2.
Is the inspection result normal?
YES- GO TO 2
NO- Check items displayed by self-diagnosis.
2. CHECK COMBINATION METER
Check if the indication and operation of combination meter are normal. Reading and Clearing Diagnostic Trouble Codes.
Is the inspection result normal?
YES- Replace ABS actuator and electric unit (control unit). Type 2.
NO- Replace combination meter. Service and Repair.
Special Repair Requirement
1. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Always perform neutral position adjustment for the steering angle sensor when replacing the ABS actuator and electric unit (control unit). Type 2.
- GO TO 2
2. CALIBRATION OF DECEL G SENSOR
Always perform calibration of decel G sensor when replacing the ABS actuator and electric unit (control unit).
Type 2.
- END