Type 1
INSPECTION AND ADJUSTMENT
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : Special Repair Requirement
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
CAUTION:
To adjust neutral position of steering angle sensor, make sure to use CONSULT
(Adjustment cannot be done without CONSULT)
1. ALIGN THE VEHICLE STATUS
Stop vehicle with front wheels in straight-ahead position.
- GO TO 2
2. PERFORM THE NEUTRAL POSITION ADJUSTMENT FOR THE STEERING ANGLE SENSOR
1.On the CONSULT screen, touch "WORK SUPPORT" and "ST ANGLE SENSOR ADJUSTMENT" in order.
2.Touch "START".
CAUTION:
Do not touch steering wheel while adjusting steering angle sensor.
3.After approximately 10 seconds, touch "END".
NOTE:
After approximately 60 seconds, it ends automatically.
4.Turn ignition switch OFF, then turn it ON again.
CAUTION:
Be sure to perform above operation.
- GO TO 3
3. CHECK DATA MONITOR
1.Run vehicle with front wheels in straight-ahead position, then stop.
2.Select "DATA MONITOR". Then make sure "STR ANGLE SIG" is within 0±2.5�.
Is the steering angle within the specified range?
YES- GO TO 4
NO- Perform the neutral position adjustment for the steering angle sensor again, GO TO 1
4. ERASE THE SELF-DIAGNOSIS MEMORY
Erase the self-diagnosis memory of the ABS actuator and electric unit (control unit) and ECM.
- ABS actuator and electric unit (control unit): Type 1.
- ECM: CONSULT Function.
Are the memories erased?
YES- Inspection End.
NO- Check the items indicated by the self-diagnosis.