Removal And Installation

FRONT FINAL DRIVE ASSEMBLY

Removal and Installation











NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

REMOVAL

1.Remove the drive shafts from the front final drive assembly. Removal And Installation.
2.Remove the front crossmember.
3.Remove the front propeller shaft from the front final drive assembly. Removal And Installation.
4.Disconnect the vent hose from the front final drive assembly.
5.Support the front final drive assembly using a suitable jack.





6.Remove the front final drive assembly bolts, then remove the front final drive assembly.

WARNING:
Support the front final drive assembly while removing using a suitable jack.

INSTALLATION

Installation is in the reverse order of removal.
- Install new side oil seals into the front final drive assembly. Side Oil Seal.

CAUTION:
- Make sure there are no pinched or restricted areas on the breather hose caused by folding or bending when installing it.
- Check the front final drive assembly differential gear oil after installation and refill as necessary.