Stall Test

INSPECTIONS BEFORE TROUBLE DIAGNOSIS

Stall Test


STALL TEST

Stall Test Procedure
1.Inspect the amount of engine oil. Replenish the engine oil if necessary.





2.Drive for about 10 minutes to warm up the vehicle so that the A/
T fluid temperature is 50 to 80�C (122 to 176�F). Inspect the amount of ATF. Replenish if necessary.





3.Securely engage the parking brake so that the tires do not turn.





4.Engine start, apply foot brake, and place shift selector in "D"
position.
5.While holding down the foot brake, gradually press down the accelerator pedal.
6.Quickly read off the stall speed, then quickly remove your foot from the accelerator pedal.

CAUTION:
Do not hold down the accelerator pedal for more than 5 seconds during this test.

Stall speed:Stall Speed

7.Move the shift selector to the "N" position.
8.Cool down the ATF.

CAUTION:
Run the engine at idle for at least one minute.
9.Repeat steps 5 through 8 with shift selector in "R" position.

Judgment of Stall Test





Stall test standard value position