Brake Pads - Abrasive Coated Design
TS82-094Nov. 12, 1982
Brakes
ABRASIVE COATED BRAKE PADS, ALL MODELS
During brake inspection and repair, if conditions are found on brake rotors which will require machining for correction, an alternate solution is now available. Nissan abrasive coated brake pads can be installed. During the first 500 miles of operation with these pads, the abrasive coating will grind off any irregularities on the rotors normally removed by machining.
Characteristics of Abrasive Coated Brake Pads
The Nissan abrasive coated brake pad consists of a standard brake pad coated with a very thin layer of abrasive material. Depending on how often and how long the brakes are used, the abrasive layer wears out during the first 500 miles, leaving the standard brake pad for continued use.
CAUTIONS: 1. If abrasive pads are required for the rear brakes, they should also be installed on the front brakes, to prevent rear wheel lockup.
2. After installing abrasive pads, test drive the vehicle and advise the owner that squealing and vibrations may temporarily occur. These symptoms are normal and will decrease gradually as the abrasive coating wears away and the normal pads are exposed.
3. Advise the vehicle owner that due to the abrasive coating which increases the coefficient of friction, brake pedal effort will be reduced. After the coating wears out, the brake pedal effort will be normal.
Refer to the appropriate Service Manual for installation instructions. Use Special Nissan Brake Grease (PDC and Silicone) when installing new parts.
Parts Information
Part Number Part Name Applied Model
41060-M6894 Pad Kit, Front Brake 310
41060-U6794 " 210
41060-N9694 " 200SX
41060-D1793 " Stanza
41060-D1794 " Maxima
41060-P9194 " 280ZX
41060-01W94 " 720
41060-B9594 " 720 C&C
44060-N9594 Pad Kit, Rear Brake 200SX
44060-04S94 " Maxima
44060-P9194 " 280ZX
NOTE: Rubber coated shims are included in each kit.
Warranty Information
CS PNC CT Operation No. Flat Rate Time
Front 2B 41061 07 BR4042 0.5
Rear 2B 44061 07 BR4044 0.5