Keyless Entry: Service and Repair

If the remote controller or the control unit needs to be replaced or if an additional remote controller needs to be set, enter the Identity (ID) code manually.

ID Code Entry Procedure
To enter the ID code, follow this procedure.
"Setting mode".

Three steps must be followed to establish the "setting mode".

1. Open the trunk.
2. Close and lock all doors.
3. Insert and remove the key from the ignition more than six times within 10 seconds.
^ At this time, the original ID codes are eliminated.

ID code entry:
4. Unlock and lock the driver's door inside lock lever once.
5. Push lock button on the new remote controller once (for example, if door is locked using the remote controller during this ID code entry enable state, a new ID code can be entered).
^ At this time, the new ID code is entered.
6. If you need to enter additional remote controllers (including the original) repeat the step (4) and (5) for each additional controller.
7. This ID code entry enable state and setting mode remain until any one of the doors is opened.

NOTE:
^ If the same ID code that existing in the memory is input, the entry is canceled, and no ID code will be entered.
^ Entry of maximum four ID codes is allowed and any attempt to enter more will be ignored.
^ Any ID codes entered after termination of the "setting" mode will not be accepted. Additionally remote control signals will be inhibited when an ID code has not been entered during the "selling" mode.