Load Compensator: Service and Repair

REPLACEMENT

CAUTION:
- Refill with new brake fluid "DOT 3". Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately. Do not reuse Load Sensing Valve once it is disassembled.
- Replace damaged Load Sensing Valve as an assembly.
- When disassembling, apply multi-purpose grease to all rubbing areas.

1. Tighten all flare nuts and mounting bolts.
- Flare nut: 15 - 17 Nm (11 - 13 ft. lbs.)
2. Refill until new brake fluid comes out of each air bleeder valve.
3. Bleed air. Refer to Brake Fluid / Service and Repair / Bleeding Brake Fluid.